LSI SAS6160 manual „ alias delete

Chapter 4: SAS Domain Manager Command Line Interface SDM-CLI Commands LSISAS6160 SAS Switch User Guide

		Usage:
		„	alias create <name> <sas address>
			Creates an alias that is bound to a specific device within the domain. The alias name
			can have a maximum of 24 characters. Valid characters are 0 through 9, A through Z,
			a through z, # (pound), - (dash), and _ (underscore). An alias name must not closely
			resemble a valid SAS address (16 hexadecimal characters that start with a 5).
		„ alias delete		single <name>
			Deletes a single specified alias.
		„ alias delete		all [noconfirm]
			Deletes all aliases. If you specify the [noconfirm] option, the deletion occurs
			immediately without an additional confirmation prompt. Otherwise, SDM first
			prompts you to confirm the action.
4.2.6	Device Command	(Intra-Domain) Use the device command to manage individual devices (LSI expanders)
		within the domain.
		Authority: Admin
		Syntax:
			device (<sas	address><alias>) reset [noconfirm]
			device (<sas	address><alias>):<phy> reset [counters]
			device (<sas	address><alias>):<phy> (disableenable)
			device (<sas	address><alias>) update <file> <ip address>
			device (<sas	address><alias>) ip (dhcpstatic <ip
			address> <mask> <gateway>)
			Configure IP	address for the switch.
		Usage:
		„	device (<sas	address><alias>) reset [noconfirm]
			Resets a device after user confirmation. If you specify the [noconfirm] option,
			the reset occurs immediately without an additional confirmation prompt.
			Otherwise, SDM first prompts you to confirm the action.
		„	device (<sas	address><alias>):<phy> reset
			Resets a phy.	address><alias>):<phy> reset counters
		„	device (<sas
			Clears a phy’s counters.
		„	device (<sas	address><alias>):<phy> disable
			Disables a phy until the next device reset.
		„	device (<sas	address><alias>):<phy> enable
			Enables a previously disabled phy.
		„	device (<sas	address><alias>) update <file> <ip address>
			Installs a new firmware image on the specified device and automatically resets the
			device after a successful update. SDM checks to ensure that the product
			identification of the image matches the targeted device. The targeted device is
			responsible for any other image validation.

Page 62 LSI Corporation September 2010