How to Use the Features

How to Use the Features

The procedures which appear in the sections, Voice Feature Procedures and Display Feature Procedures, give short, step-by-step instructions for using each feature. For your convenience, the features in each section are listed alphabetically.

General Instructions

Use the following special instructions for operating your voice terminal.

The first time you use these procedures, you will need to customize them for yourself by obtaining the following information from your system manager:

Your system manager may assign call appearances or features to the 5 call

appearance/feature buttons on your voice terminal. To the right of each feature name in this section is a box. For each feature that you have on your voice terminal or feature you can access with the softkeys (see “Note” below),

mark a in the blank box as a reminder. (The Conference, Drop, Hold, Message, Mute, Select Ring, Test, and Transfer voice features, for all sets, and the Normal/Exit mode display feature, for users of the 8405D or 8405D Plus, are already marked for you.) You may also be able to use the Speakerphone (and Reset Speakerphone on some 8405B Plus and 8405D Plus voice terminals) or the Speaker feature. Check with your system manager to see what other features you can use with a DEFINITY Generic 2 or with System 85.

Note: If you are using an 8405D or 8405D Plus voice terminal, you may also be able to use up to 12 additional features accessed with the softkeys and display control buttons. Check with your system manager to see which softkey features are available on your voice terminal and then put a check in the box beside each of those features.

Any feature not appearing on a button or accessed with the display and softkeys can be activated or canceled by dialing a 1-, 2-, or 3-digit feature access code. Ask your system manager for the feature access codes for the features you need, and then write the assigned code number in the provided blanks in each feature procedure.

If you receive an intercept tone (high-pitched, alternating high and low tone) while attempting to operate any feature, you have taken too much time to complete a procedural step or have made a dialing error. Hang up, get dial tone, and begin again at Step 1.

11

Page 15
Image 15
Lucent Technologies 8405 manual How to Use the Features, General Instructions