Lynx Professional Grills L36R-1 LeArAn C e To Co M Bustible mATERIALS, ReAr hood C leArAn C e

noTe

lynx built-in grills are intended either for installation in a built-in enclosure constructed of non-combustible materials or for an installation in a built in enclosure constructed of combustible material when installed with a Lynx insulating jacket (LIJ).

for non-combustible applica- tions, the grill drops into the opening shown in the cutout detail drawing (see indeX: “ g as requirements”) and hangs from its counter-top trim. A deck is not required to support it from the bottom.

When using the insulated jacket in a combustible enclosure, the jacket must be supported from the bottom by a ledge on each side or a full deck beneath the jacket.

(see indeX: “ g as requirements”)

C leArAn C e To Co M-

BUSTIBLE mATERIALS :

m inimum clearance from the sides and back of the grill to adjacent combustible con struction below the top of unit are 12” from the sides and back.

dégagement minimal entre les parois latérales et l’arrière de l’appariel et la construc tion combustible au-dessous du panneau supérieur de l’appareil (30 cm à partir des parois latérales et 30 cm à partir de l’arrière).

m inimum clearance from sides and back of unit to adjacent combustible con struction extending above the unit is 18” from the sides and back.

dégagement horizontal minimal entre les parois

latérales et l’arrière de l’appariel et la construction verticale combustible au- dessus de l’appareil (45.7 cm

àpartir des parois latérales et 45.7 cm à partir de l’arrière).

do not use this appliance under overhead combustible surfaces.

n e pas utiliser cet appareil sous une surface combus tible.

A minimum of 6” of clearance is needed on the left side of the grill above the counter top for the motor and skewer.

If the grill is to be placed into a combustible enclosure, an approved insulated jacket

is necessary and is available only from your Lynx dealer. Lynx insulated jackets have been designed and tested specifically for your g rill.

Pay special attention to the provisions shown for gas line hook-up.

The enclosure should have ventilation holes to prevent gas build-up in the event of a leak. The deck ledges and counter should be flat and level. (refer to Ansi Z21.58 Enclosures for Self contained lP-g as s upply systems or local codes for additional information)

This grill requires that a 120 volt, 60 hertz, 15 amp gfi certified outlet be installed by a qualified electrician.

reAr hood C leArAn C e

A  inch clearance is required behind the grill to allow the front hood to open.

The grill exhausts combustion products and cooking greases to the back. n ever locate the grill where this exhaust will be difficult to clean.

28