Lynx Professional Grills L54PSR-1 One lAsT T hing, RAss b urner flAM e/ Air f low AdjusTM enT

►Pull off the control knob.

►While holding the valve shaft with pliers, insert a thin flat-blade screwdriver into the shaft and, while watching the flame, adjust it to a minimum stable setting.

be about 3/8 inch high with a total flame height of about 1 1/2 inches.

The flames should burn quietly. (no “torch” sounds) and they should not “lift” up from the burner.

f your flames do not match hose indicated in the photo, nsure that the air shutter and urner ports are free and clear f dirt, debris, or spider webs. f clear, then adjust the air hutter.

t is locked in place by a screw hich must be loosened efore adjusting. o nce djusted retighten the screw.

►i f the flame is noisy (sounds like a torch) and tends to lift away from the burner, indicating too much

air, turn the air shutter clockwise.

►After the burner cools down, remove it, tighten the air shutter set screw and reinstall the burner, briquette trays and grill racks.

one lAsT T hing:

finally, before leaving, check all the burners for proper operation. m ake sure the control knobs turn freely and completely through their full

b rAss b urner flAM e/ Air f low AdjusTM enT

The amount of air that enters a burner is controlled by the air shutter

Each grill burner is tested and adjusted at the factory prior to shipment. h owever, fluctua- tions in gas pressure, gas con version and even in the quality of the gas itself may make it necessary to adjust the burner.

The flames of the main brass burners should be visually

stable with slight yellow tips. The bright-blue core should

to adjust:

danger!

Be extremely careful

around hot B urners and other grill parts.

►Remove the racks and briquette trays.

►Lift out the burner, loosen the set screw and then put the burner back in place and light it.

i f the flame is excessively yellow, indicating insuf ficient air, CArefully turn the air shutter counter clockwise to allow more air to the burner.

range.

Im Portant:

m ake sure the owner knows where the main gas supply shut off valve is located.

finally, for safety and for proper use & care, you must leave this manual with the owner m ake sure you advise them to keep it for future reference.

for technical assistance call:

lynx technical s upport

888-289-5969

35