►Keep any threading compound off of the first two pipe threads to avoid having any small pieces of compound break loose and clog a burner valve or orifice. do not put sealant on any male end of flare fittings
Keep last two threads clean
for built-in ommen
pipe used be kept as short as possible. (see indeX: “ g as
Connections” for typical permanent hook up.)
for freestanding units using natural gas, Lynx strongly recommends using a quick
lP gAs
g rills set up for lP gas come equipped with an lP hose/ regulator assembly for con nection to a standard 20 lb. lP cylinder. (Type 1). All fittings necessary to attach the assembly to the grill are
i
Permanently plumbed lP con- nections, such as those in line with a bulk cylinder, require
a4/11 regulator. (lynx P/n 30781)
i f you are using a 4/11
m axitrol regulator, ensure that it is set for the correct fuel by adding or removing the cap 
asket as shown below.
gas line to the grill.
warning
Do not change the regulator/hose assembly or use any other assembly than the one supplied with your Lynx grill.
Do not attempt to use a
Do not store a spare 
cylinder under or near this 
appliance
Never fill the cylinder beyond 80 percent full
If the information above is not followed exactly, a fire causing death or serious injury may occur.
lP Cylinder
requirements
The lP cylinder must be con- structed and marked in accor dance with the specifications for lP gas cylinders of the u s department of Transportation
(doT) and designed for use with a Type 1 system only.
cylinders must be secured sing the provided cylinder etention system to avoid ccidental movement.
cylinder for a refill, exchange only for a Type 1 20lb cylinder with an
n ever use a cylinder with a damaged valve.
A dented or rusty lP cylinder may be hazardous and should be avoided. If in doubt, have it checked by your lP supplier.
Always check for leaks after every lP cylinder change.
(see indeX: “ leak Test” for further details.)
Always shut off the
cylinders must be stored outdoors in a
connection
