2.5Relay Connection
All poles of the three relays are available at the modular connector J2 (see Figure
NC | NO | C | NC | NO | C | NC | NO | C |
R1 | R1 | R1 | R2 | R2 | R2 | R3 | R3 | R3 |
1 |
|
|
|
|
|
|
| 9 |
Insert this face of connector
into mating connector on
control circuit board.
Figure 2-2 Relay Connector
To install the wiring for the relays, disconnect the connector from the header on the PCB. Strip the insulation of each wire back approximately 1/4 in. (6.5 mm), insert the bare wire into the terminal and tighten the screw clamp. Ensure that the wire cannot easily be pulled from the connector.
Note that the panel configuration can designate
Refer to Table
Signal Name | Connector- | Signal Name | Connector- | Signal Name | Connector- |
| Pin Number |
| Pin Number |
| Pin Number |
Relay 1 NC | Relay 2 NC | Relay 2 NC | |||
Relay 1 NO | Relay 2 NO | Relay 2 NO | |||
Relay 1 Common | Relay 2 Common | Relay 2 Common |
Table
Revision 0.07 | 12 |