Macurco DVP-120 operating instructions Table Of Contents

TABLE OF CONTENTS
1	INTRODUCTION		5
	1.1	General Information	5
	1.2	Features	5
	1.3	Compatible Macurco Transducers	5
	1.4	Specifications	8
	1.5	Warranty	8
	1.6	Return Instructions	8
2	Installation & Connection		9
	2.1	Mounting the DVP-120	9
	2.2	General Wiring Information	9
	2.3	Main power Connection	10
	2.4	Remote Sensor Connection	10
	2.5	Relay Connection	12
	2.6	Horn & Strobe Connection	13
	2.7	Interfacing Macurco Sensors	14
3	Operation		15
	3.1	Initial Operating Mode	15
	3.1.1	Status Light Display	15
	3.1.2	User Interface	16
	3.1.3	Normal Status Display	17
	3.1.4	ALARM Status Display	17
	3.1.5	Warning Status Display	18
	3.1.6	Trouble Status Display	18
	3.2	Ventilation control	19
	3.2.1	Zone Signal Display	19
	3.3	Setting the System Configuration	20
	3.3.1	System Menu	21
	3.3.2	Configure System Submenu	21
	3.3.3	Configure Sensors Submenu	24
	3.3.4 Configure Relays, Horn & Strobe Submenu		26
	3.3.5	Configure Horn Submenu	27
	3.3.6	Configure Strobe Submenu	28
	3.3.7	Configure Zones Submenu	29
	3.3.8	Configure Signals Submenu	32
4	Troubleshooting		36
	4.1	System Status Light Flashing	36
	4.1.1	Input Channel Trouble	36
	4.1.2 Internal Controller Board Trouble		36
	4.2	Timed ventilation problem	36
	4.3	No Power	37
	4.4	LCD Display unreadable	37
	4.4.1 Hold the MENU key for three (3) seconds		37
	4.4.2 Press the UP and DOWN cursor keys to change the LCD contrast		37
	4.4.3 Press any other key to exit the contrast-setting mode		37
	4.5	The Keypad does not respond (LCD shows KEYS LOCKED)	37
	4.6	After a power failure	37
LIST OF FIGURES
Figure 1-1 System Wiring Diagram			6
Figure 1-2 DVP-120 Internal View			7
Figure 2-1 Sensor Interface Connector			10
Figure 2-2 Relay Connector			12
Figure 2-3 Horn & Strobe Connector			13
Figure 3-1 Model Display			15
Figure 3-2 Warm-Up display			15
Figure 3-3 Keypad layout			16

Revision 0.07 2