Macurco DVP-120 operating instructions S t r o b e 5N o r m . O f f D e l a y O n

3.3.6 Configure Strobe Submenu

The configuration parameters for the strobe are the same as those for relays. A strobe would not normally require a minimum on time but this parameter allows a more versatile configuration.

3.3.6.1 Strobe Summary

S t r o b e 5 N o r m . O f f

D e l a y O n

Figure 3-37 Strobe Summary

This display example shows that the strobe has been configured to operate Normally Off, with a turn on delay and no minimum on time.

Notice that the strobe number, 5, is underlined. This indicates that the digit keys can be used to jump to a particular relay, horn or strobe. The relays are numbers 1, 2 and 3; the horn is number 4 and the strobe is 5.

3.3.6.2 Strobe Mode

S t r o b e	N o r m . O f f
M o d e : 2

Figure 3-38 Strobe Mode

This display example shows that the strobe is configured to operate in the Normally Off mode. The valid modes are:

–2 Normally Off (default)

–3 Normally On

3.3.6.3Strobe Turn On Delay

S t r o b e		D e	l a y	O n
( m m : s s	)	0 1 : 0 0

Figure 3-39 Strobe Turn On Delay

The default turn on delay is one minute and the maximum allowed value is fifteen minutes.

3.3.6.4 Strobe Minimum On Time

S t r o b e		M i n	. O n
( m m : s s	)	0 0 : 0 0

Figure 3-40 Strobe Minimum on time

The default minimum on time is zero and the maximum allowed value is fifteen minutes.

Revision 0.07 28