P 18/ 37
Repair
[3] DISASSEMBLY/ASSEMBLY
[3]-6. Positive lock mechanism of Turn base
DISASSEMBLING
Fig. 40
(1)Remove Stop ring
Grip 50, Compression spring 11, Flat washer 10 and Cam can be removed.
(2)Remove M6x14 H.S.Binding head screw then remove Miter lock plate in the direction designated with black arrow. (Fig. 41)
(3)Remove CT 4x16 Tapping screw (2pcs.) and Lock lever plate. (Fig. 42)
(4)Push Lock pin 6 in the direction designated with black arrow and pick up Lock lever in the direction designated with gray arrow. (Fig. 43)
(5)Remove Pin 3 from Lock pin 6, then pull out Lock pin 6 in the direction designated with black arrow. (Fig. 44)
Stop ring |
Cam |
Compression spring 11 |
Flat washer 10 |
Grip 50 |
Turn base |
Groove for Stop ring |
Fig. 41 | Fig. 42 |
M6x14 H.S.Binding head screw 
Turn base
Miter lock plate
Compression spring 13
Pin
Miter lock plate
Miter lock plate can be pulled out without removing Pin.
Lock lever plate | CT4x16 |
| Tapping screw |
| (2pcs.) |
Fig. 43
Lock lever | Lock pin 6 |
ASSEMBLING |
|
Fig. 44
Compression Pin 3 | Lock pin 6 |
spring 6 |
|
Assemble Turn base section as illustrated in Fig. 45. And then, take the disassembling step in reverse. Refer to Fig. 37.
Fig. 45
Apply Grease to Slide plate and the center hole of Base before assembling Turn base section.
Turn base section has to be tightened with M8x45 Hex bolt so that it can smoothly turn without wobbling.
M8x45 Hex bolt
Flat washer 8
Slide plate
Base
Lock lever
While pressing down Lock lever, fit Turn base section to Base.
