Repair
[3]DISASSEMBLY/ASSEMBLY [3]-1. Blade case, Motor section
DISASSEMBLING
Note: Refer to Fig. 7. The three notches on Blade case have important role for disassembly / assembly.
(1)Disconnect the linkage of Blade case with Arm and Base section by removing Strain relief and Link plate as illustrated in Figs. 8 and 9.
Fig. 8
P 6/ 37
Fig. 7
Blade case | notch A: locking Blade case to |
| |
| Base at 90 degrees |
| notch B: locking Blade case |
| at starting position |
| notch C: locking Blade case |
| at the lowest position |
Aligning notch B with Stopper pin, push Knob 20 toward the notch. Blade case can be locked at starting position.
Blade case
Remove Strain reliefs from Arm complete and Blade case by unscrewing 4x12 Tapping screw (2pcs.).
Strain relief
notch B | 4x12 Tapping screw |
|
Strain relief
Knob 20 
4x12 Tapping screw
Remove M4x10 Pan head screw (2pcs.) for Guard as illustrated below and then separate Guard section.
M4x10 Pan head screw (2pcs.)
Guard section 
Fig. 9
Remove Link plate as illustrated below.
Link plate complete
1. Remove Stop ring
Stop ring
Flat washer 6
Ring 6
2. Remove M6x20 Hex socket head bolt, Flat washer 6 and Ring 6. Link plate complete can be free from Front arm.
M6x20 Hex socket head bolt
Flat washer 6
Ring 6
