P 19/ 37
Repair
[3] DISASSEMBLY/ASSEMBLY
[3]-6. Positive lock mechanism of Turn base (cont.)
ASSEMBLING
Note: Assemble Grip 50 to Miter lock plate as illustrated in Fig. 46 so that the notch of Cam portion faces the upper side.
Fig. 46
Miter lock plate |
notch of Cam portion |
of Grip 50 |
[3]-7. Assembling of Square rod complete
Match both ends of Square rod complete with the notches of Arm holder complete on condition that the notches are closest position to the center of Turn base, and tighten M5x30 Hex bolt (2pcs.) as illustrated in Fig. 47.
Note: Face the concave of Square rod complete to the center of Turn base.
Fig. 47
M5x30 Hex bolt (2pcs.) | Arm holder complete | |
notches of |
|
|
Arm holder |
|
|
complete |
|
|
threaded holes of | Square rod | center of |
Arm holder complete | complete | Turn base |
[3]-8. Stopper pin
DISASSEMBLING
1)Push Knob 20 to lock Blade case at highest position in the moving range.
Then remove M6x20 Hex socket head bolt for securing Link plate. (Fig. 48)
2)Lower Blade case slightly to hold Stopper pin, turn Knob 20 counterclockwise a little.
Note: Do not remove Knob 20, or Stopper pin will not be pulled.
3)Remove Blade case section according to the step shown in clause
4)Remove Knob 20 from Stopper pin, and then pull out Stopper pin in the direction designated with black arrow in Fig. 48.
ASSEMBLING
Take the disassembling step in reverse.
Note: Apply Makita grease SG No.00 to O ring 5 that is fit into Stopper pin. Refer to Fig. 1.
Fig. 48
Knob 20 | Stopper pin |
Link plate | M6x20 Hex |
complete | socket head bolt |
Flat washer 6 | |
| Ring 6 |
