Manitowoc Ice QF0400, QF2300, QF0800, QC0700 manual Ice Chute Removal

Section 3 Ice Machine Operation

Ice Chute Removal

QC700/QF800

1.Follow steps to remove float reservoir.

2.The ice chute and ice chute grommet will be removed as a unit. Pull forward on the top of the ice chute, and slide the ice chute and grommet off the end of the evaporator spout.

3.Remove evaporator spout insulation.

4.Lift ice chute out of the base.

5.Remove insulation from the bottom of the ice chute.

6.Remove bin level sensor (stainless steel plate) from ice chute. (Bin level sensor can be disconnected from the control board for complete removal from the ice machine.)

NOTE: Clean and sanitize the base and all ice chute components before reinstalling.

6

3

2

4

5

SV2011

QF2300

1.Place the toggle switch in the OFF position, turn off the water supply and disconnect electrical power to the ice machine.

2.Remove ice chute retaining clamp from top of evaporator.

3.Remove vinyl hose from ice chute spout.

4.Follow steps to remove water reservoir.

5.The ice chute elbow and the ice chute will be removed separately. Support the ice chute and pull forward on the elbow to remove.

6.Lift ice chute out of the base, tip bottom forward and remove bin level sensor (stainless steel plate) from the top of the ice chute. (Bin level sensor can be disconnected from the control board for complete removal from the ice machine.)

7.Remove insulation from ice chute elbow and ice chute base.

8.Remove evaporator spout o-ring.

NOTE: Clean and sanitize the base, spout and all ice chute components before re-installing.

4 2

5

8 3

6

7

SV1787

Part Number 000002688 3-15