Marantz PMD570 manual Copyright

	ANTENNA
	LEAD IN
	WIRE
GROUND	ANTENNA
CLAMP	DISCHARGE
	UNIT
	(NEC SECTION
	810-20)
ELECTRIC	GROUNDING
SERVICE
	CONDUCTORS
EQUIPMENT
	(NEC SECTION
	810-21)
GROUND CLAMPS	POWER SERVICE
	GROUNDING
	ELECTRODE SYSTEM
	(NEC ART 250, PART H)

FIGURE 1

EXAMPLE OF ANTENNA GROUNDING AS PER

NATIONAL ELECTRICAL CODE, ANSI/NFPA 70

NEC - NATIONAL ELECTRICAL CODE

NOTE TO CATV SYSTEM INSTALLER:

This reminder is provided to call the CATV (Cable-TV) system installer's attention to Article 820-40 of the NEC, which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful inter- ference in a residential installation. This equipment generates, uses and can radiate radio frequency en- ergy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guaran- tee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is con- nected.

•Consult the dealer or an experienced radio/TV tech- nician for help.

NOTE:Changes or modifications may cause this unit to fail to comply with Part 15 of the FCC Rules and may void the user's authority to operate the equipment.

WARNINGS

Do not expose the equipment to rain or moisture.

Do not remove the cover from the equipment.

Do not insert anything into the equipment through the ventilation holes.

Do not cover the ventilation with any items such as tablecloths, newspapers, curtains, etc.

No naked flame sources, such as lighted candles, should be placed on the equipment.

When setting up the recorder ensure that:

•it will not be exposed to interference from external equipment.

•it will not be exposed to electrostatic dis- charges.

•it will not be exposed to direct sunlight.

•heavy objects are not placed on the recorder.

Copyright

Recording and playback of any material may require consent. For further information refer to the following US ordinances:

•Copyright act of 1956

•Dramatic and Musical Performance Act 1958

•Performers Protection Acts 1963 and 1972

•any subsequent statutory enactments and orders

- 4 -