Putting Tape and Sheet, Treatment device | Matsushita CF-W5LWEZZ1 2

9.3.5.5. Putting Tape and Sheet

FFC bend part	Processing	Conduction cloth is processed
edge standard	between bosses	straight next to the boss.

Slack is processed under the tape.

A both sided tape is fixed while installed in the

FFC positional putting out treatment device.

Boss central standard

				Refer to the affixation
				specification to Figure 2
				The coaxial cable is processed
				between the battery and the boss.

				Convex side

	Screw

Boss central		Refer to		Fixation after processing
standard		Refer to		not put on convex side of
		Figure 1		bottom is done

				Affixation matched to plinth
			externals (left chart red line)
			A curved surface side is affixed
			to bottom case.

	Figure 1	Installation placed	Fixes with the tape after
		between bottom case	the cable is processed below.
Safety work			(Securing of drive and clearance)
Safety work
				Figure 2
A remaining amount is inserted				Figure 2
A remaining amount is inserted
under the substrate.
Do not process the cable under
MIC,H/P jack.

Modem connector installation

Inserts in positioning pin.

USB board installation

Safety work

Processing which passes side of connector Slack is lost by processing the cable in the direction of the arrow when slackening.

Inserts in positioning Pin.

Modem cable is prevented

from running aground to the boss. Cable positional accuracy is put out about this size with a cable positioning treatment device.

Bottom corner standard Putting