Maytag RCS10DA General Information, Unpacking Equipment, Equipment Placement, Radio Interference

General Information

Unpacking Equipment

•Inspect equipment for damage such as dents in door or dents inside oven cavity.

•Report any dents or breakage to source of purchase immediately. Do not attempt to use oven if damaged.

•Remove all materials from oven interior.

Equipment Placement

•Do not install equipment next to or above source of heat, such as pizza oven or deep fat fryer. This could cause microwave oven to operate improperly and could shorten life of electrical parts.

•Do not block or obstruct air filter. Allow access for cleaning.

•Install on level countertop surface.

A

A

A

A—Allow at least 1½ inches / 3.81 centimeters of clearance around top and sides of equipment. Proper air flow around equipment cools electrical components. With restricted air flow, oven may not operate properly and life of electrical parts is reduced.

Radio Interference

Microwave operation may cause interference to radio, television, or similar equipment. Reduce or eliminate interference by doing the following:

•Clean door and sealing surfaces of oven according to instructions in “Care and Cleaning” section.

•Place radio, television, etc. as far as possible from oven.

•Use a properly installed antenna on radio, television, etc. to obtain stronger signal reception.

Oven Features

Removable

Splatter Shield

(Not Shown)

Oven Door Window

and Interior Light

Oven Display

Oven Control

Pads

Filter

©2004 Maytag Services 16023293 Rev. 0 9