Maytag RCS Disassembly Procedures, Disconnecting Wire Terminals, Outer Case, Grasp, Pull, Release

Disassembly Procedures

!WARNING

To avoid the risk of electrical shock, personal injury, or death, disconnect power to oven and discharge the capacitors before following any disassembly procedure.

High voltage is present at the high voltage terminal of the high voltage transformer during any cooking cycle.

It is neither necessary or advisable to attempt measurement of the high voltage.

Before touching any oven components or wiring, always unplug the oven from its power source and discharge capacitor.

Disconnecting Wire Terminals

All wire terminals are locking-type terminals. Proceed as follows to disconnect wire terminals:

Insulated terminals:

Grasp insulator pod and pull back.

DO NOT PULL ON WIRE.

1 Grasp		Wire
Insulator	2	Pull
Pod

Non-insulated terminals:

Use a small blade screwdriver to depress locking-tab and pull on terminal.

DO NOT PULL ON WIRE.

1	Release	Wire
	locking-tab
	2 Pull

Outer Case

1.Disconnect power to oven.

2.Remove screws securing outer case to unit.

3.Slide outer case towards rear of unit.

4.Reverse procedure to reassemble.

! CAUTION

During disassembly some foam gaskets may require removal. These components must be replaced for proper circulation of air over the components and through the oven cavity.

©2004 Maytag Services 16023293 Rev. 0 25