How to Operate the MDLP2
Power
The Red LED to the left of the STANDBY/ON
Notes: 1. It is normal for the projector lamp warm up period to last about a minute before an image appears on the screen.
2.If the Initial Setup for the MDLP2 has not yet been performed refer to page 14 at this time.
Source Selection
The default Source Select for the MDLP2 Projector is the COMPonent 1 Input. There is an additional Component Video Input (COMP 2) along with two HDMI Inputs. Select the desired source using the
Note: Whenever possible use HDMI connections between the source device output to the MDLP2 Input. This will yield better image quality, as the video signal will go through one less analog to digital conver- sion process and possibly one less digital to analog conversion process as well.
2 
Figure 14
Image Adjustments and Setting changes
All of the electronic based image adjustments and pro- cessing settings are performed by using the extensive
active and the ability to change
a given setting is dependent on the Input selected, the presence of a video signal for that input, the Picture Mode selected and are automatically saved for the cur-
rently selected video input. When
a menu item is “grayed out” it can not be changed until either another Input is selected, a signal is present or a different Picture mode is selected.
The selection of a menu item
and the available choices/adjust- ments are performed by using the Navigation (◄LEFT, ►RIGHT, ▲UP or ▼DOWN)
the Remote Control
tation, Display Vertical Keystone
Adjustment and Remote Control Configuration. All of the remain-
ing menu options are performed in a similar manner.
22
