Installation
Installation Overview
For the best possible image reproduction by the McIntosh MDLP2 Video Projector, it is important to observe the fol- lowing:
CAUTION: The MDLP2 Video Projector weight is 40 pounds (18.14 kilograms). When mounting the projector to a building structure it is important to follow all of the local building/constuction codes.
1.Decide on a viewing area with either subdued and/ or controlled ambient lighting.
2.Choose a projector screen designed specifically to work with images from a DLP Projector.
3.Locate the position of the MDLP2 Projector rela- tive to the projector screen to maximize image quality and minimize optical distortions.
4.Provide adequate ventilation.
The information below and on the following pages will as- sist in the location of the Projector. It is recommended that the Professionals at your McIntosh Dealer, who are skilled in all aspects of installation and operation, install the MDLP2 Video Projector and any associated audio/video equipment.
Ventilation
Always provide adequate ventilation for your MDLP2. Cool operation ensures the longest possible operating life for any electronic instrument. Do not install the MDLP2 directly above a heat generating component. Refer to fig- ures 1 and 2.
The MDLP2 is designed to be placed upright on a solid flat surface, resting on its three feet with unrestricted air flow around it. Allow at least 1 foot (30.48 cm) of space between the Primary Warm Air Exit ventilation holes and the nearest wall or obstruction. There should be at least 3 inches (7.62 cm) between the Primary Cool Air Input ventilation holes and the nearest wall or obstruction. The ambient air temperature should not exceed 95°F (35°C).
The projector uses two primary and three secondary cool air input vents together with one primary warm air exit vent. Refer to the illustration on this page. The air flow in or out of these vents needs to be unrestricted at all times during operation.
In the event the MDLP2 is to be placed into an enclo- sure restricting air flow around the projector, some type of ducted forced air venting system would need to be imple- mented for the primary input 1 and 2 vents along with the primary exit vent.
Primary
Warm Air
Exit
MDLP2 Bottom View
Secondary Cool Air |
|
Input No. 2 |
|
Secondary Cool Air |
|
Input No. 3 | Primary |
| Cool Air |
| Input No. 2 |
Figure 1
Primary
Cool Air
Secondary Cool AirInput No. 1 Input No. 1
MDLP2 Rear View
2 |
Figure 2
9
