McIntosh MDLP2 owner manual General Information

General Information

General Information

CAUTION: To prevent possible damage to the Projec- tor Lens Assembly, DO NOT at any time attempt to LIFT, CARRY or RE-ORI- ENT the Projector using the Lens.

1.The Main AC Power going to the MDLP2 and any other

McIntosh Component(s) should not be applied until all the system components are connected together. Failure to do so could result in malfunctioning of some or all of the system’s normal operations. When the MDLP2 and other McIntosh Components are in their Standby Power Off Mode, the Microprocessor’s Circuitry inside each component is active and communication is occurring between them.

2.For additional connection information, refer to the owner’s manual(s) for any component(s) connected to the MDLP2 Video Projector.

3.To protect the Projector Lens from possible damage, it is advisable to keep the Lens Cover on the Projector during the following:

a.Transporting of the projector.

b.Installation and connection of the projector.

c.During the installation of other items and/or remodeling of the room where the projector is located.

4.The Projector Lens is a precision optical device with special coatings just like you would find on Profes- sional Cameras. In the event the Lens requires cleaning to remove airborne particles such as dust and dirt from the Lens, use a safe cleaning product such as a clean and dry 3MTM Scotch-Brite®Microfiber Lens Cleaning Cloth. At no time should ordinary household cleaning products be used to clean the Lens, as damage will oc- cur.

5.A McIntosh Power Controller may be added to the MDLP2 to provide AC Power Switching to components without Power Control Connections, such as a motor- ized projection screen. See your McIntosh Dealer for additional information.

6.The IR Input, with 1/8 inch mini phone jack, is config- ured for non-McIntosh IR sensors such as a Xantech Model 291-80 or equivalent. To avoid possible interac- tion, the MDLP2 Sensors may be disabled by activat- ing the On-Screen Menu, then select from the menu

Config→Remote Control→Wired. Then deactivate the On-Screen Menu. Refer to the “How to Operate the MDLP2” starting on page 23.

7.The On-Screen Menu System for adjustment of set- tings is interactive and Video Input type based, make sure to select the desired Video Input and Picture Mode before attempting to change the settings.

8.The MDLP2 has two Component Video Inputs for analog video signals and two HDMI Inputs for Digital video signals. The On-Screen Menu System has selec- tions for Composite Video, S-Video and RGB Inputs. Those inputs have no functionality when selected on the MDLP2.

9.When discarding the unit, comply with local

rules or regulations. Batteries should never be thrown away or incinerated but disposed of in accordance with the local regulations concern- ing battery disposal.

10. For additional information on the MDLP2 and other McIntosh Products please visit the McIn- tosh Web Site at www.mcintoshlabs.com.

3MTM is a trademark of the 3M Company and Scotch-Brite®is a registered trademark of the 3M Company.

5