28
Note: A table on this page is provided to record the
new Loudspeaker Volume Level Adjustments.
5. To exit the from the Automatic Loudspeaker Test
Mode, press the SELECT Push-button.
Note: Previously measured Loudspeaker Volume
Levels may be re-entered manually by using
the Directional and Select Push-buttons.
6. Use the Directional Push-buttons to highlight the
Exit Button Icon, press the SELECT Push-button
followed by the pressing the RETURN Push-but-
ton.
7.Continue next to Digital Audio Output or exit the
Setup Mode by pressing the RETURN Push-button
and the MVP851 will return to normal operation.
How to Set Audio Parameters, con’t
Location Default Setting New Setting
Front (L&R) Reference Reference
Cente r 0dB
Right Surround 0dB
Left S urround 0dB
Subwoofer 0dB

Loudspeaker Levels

Loudspeaker Default Setting New Setting
Front (L&R) Large
Center Large
Surround (L& R) Large
Subwoofer Y es
Loudspeaker Size
Location Distance Differences Default Setting New Setting
Front (L&R) 0 - -Center 0msSurround (L& R) 0ms

Loudspeaker Time Delay

Digital Audio Output
This feature either activates or deactivates the Digital Out-
put Signals at the Optical and Coaxial Digital Audio Con-
nectors located on the rear panel of the MVP851.
1. Press the SETUP Push-button on the Remote Control
to access the Setup Disc Menu. Refer to figure 4 on
page 18 and figure 8 on page 19.
2. Use the Right or Left directional Push-buttons to
select the Audio Menu Icon Tab.
3. Select the Digital Audio Output Button Icon by using
the Up or Down directional Push-buttons followed
by the SELECT Push-button. Refer to figure 22 on
page 24.
4. Use the Up or Down directional Push-buttons and
choose either On or Off Button Icon followed by the
SELECT Push-button. Refer to figure 35.
Note: The Digital Audio Output must be set to On when
either the Optical and Coaxial Digital Audio
Output is connected to an external A/V Control
Center or Digital Surround Sound Processor.
5. Continue next to PCM Down Conversion or exit the
Setup Mode by pressing the RETURN Push-button and
the MVP851 will return to normal operation.
PCM Down Conversion
This feature either activates or deactivates the PCM (Pulse
Code Modulation) Down Conversion Circuitry. Some of
the DVDs have Digital Audio Signals recorded at a much
higher sampling rate of 96kHz. The MVP851 will auto-
matically decode these Digital Audio Signals for the Ana-
log Audio Outputs. It will also digitally down convert these
signals to 48kHz and make them available at the Digital
Audio Outputs. If the A/V Control Center or Surround Pro-
cessor can accept the Digital Audio Signals at the sampling
rate of 96kHz, perform the steps below.
1. Press the SETUP Push-button on the Remote Control
to access the Setup Disc Menu. Refer
to figure 4 on page 18 and figure 8 on
page 19.
2. Use the Right or Left directional
Push-buttons to select the Audio Menu
Icon Tab.
3. Select the PCM Down Conversion But-
ton Icon by using the Up or Down
directional Push-buttons followed by
the SELECT Push-button. Refer to fig-
ure 22 on page 24.