Video Setup, con’t
4.Return to the Video Setup Menu by pressing the Left followed by the Up directional
5.Next continue to the AUDIO/VIDEO SYNC Settings. If no other changes are to be made in Setup Mode at this time, exit by pressing the RTRN (Return) Push- button.
Note: The SETUP
Audio/Video Sync
Due to the difference in the amount of time it takes for the processing of the Video and Audio signals, they can be out of synchronization which is especially noticeable with dialog. The MVP871 allows for the correction of any loss of sync. There are separate settings for HDMI (Digital Video), Analog Video (both Interlaced and Progressive Scan modes) and OTHER which is a variable setting with an offset delay
1.Press the SETUP
press the Right directional
Icon Tab. Refer to figure 24.
Note: If there is a Disc playing in the MVP871 press
the
STOP
Push-
button twice before pressing the SETUP
2.Use the Down directional
select the AU- |
|
DIO/VIDEO |
|
SYNC Menu. |
|
Refer to figure |
|
31. |
|
3. To change from |
|
the default |
|
setting use the |
|
Right direc- |
|
tional | Figure 31 |
ton followed by |
|
Up or Down directional
select OTHER followed by
the SELECT
Use the Up or Down direc- tional
by the SELECT
Note: The title of the icon
4.Return to the Video Setup Menu by pressing the Left followed by the Up directional
5.Next continue to the SQUEEZE MODE Settings. If no other changes are to be made in Setup Mode at this time, exit by pressing the RTRN (Return)
Note: The SETUP
Squeeze Mode
When the MVP871 is connected to a TV/Monitor with ei- ther a Component Video or HDMI connection and the TV Aspect Ratio is set to 16:9 and a video source with an As- pect Radio of 4:3 is displayed, the image will be stretched out. The Squeeze Mode will compensate by displaying the 4:3 image in the center of the screen. The default setting is Off with additional choices of On or Auto. To change from the default setting perform the following steps:
1.Press the SETUP
Note: If there is a Disc playing in the MVP871 press the STOP
2.Use the Down directional
3.To change from the default setting use the Right directional
28