McIntosh MVP871 owner manual SETUP, con’t, Refer to figures 11 and 2.Press the

Figure 12

SETUP, con’t

35Hz within -3dB of the midrange frequencies it is consid- ered SMALL.

1.Use the Up or Down directional Push-button to se- lect SPEAKER CONFIGURATION followed by press- ing the SELECT Push-button on the Remote Control.

Refer to figures 11 and 12.

2.Press the

Down direc- tional Push-

button and then press the Right direc- tional Push-but-

ton followed by the Up

or Down directional

Push-button

to select Large or Small Loudspeaker Size for the Front Loudspeakers connected in the system. Using the directional push-buttons and the On-Screen Menu proceed to the remaining Loudspeakers in the system and select Large, Small or None.

Note: If the Front Loudspeakers are set to small, the Center and Surround Loudspeaker will automati- cally switch to small with the Large Menu Setting grayed out. The Subwoofer setting is fixed to the On setting as this is required to playback DVD-Au- dio Discs properly.

3.Use the Down directional Push-button to select CROSSOVER press the Right directional Push-but- ton followed by using the the Up or Down direc- tional Push-buttons followed by pressing the SELECT Push-button to select the crossover frequency between the subwoofer and the Front/Surround Loudspeakers. Refer to the Owner’s Manuals that came with your Loudspeakers and/or contact your McIntosh Dealer for assistance in determining the appropriate Crossover Frequency.

4.Press the RTRN (Return) Push-button to return to the SPEAKER CONFIGURATION Menu.

CHANNEL LEVEL ADJUSTMENTS:

A properly setup Home Theater Surround Sound System should have all Loudspeaker levels adjusted to the same starting reference volume level in the Listening/Viewing Area. The MVP871 includes a built-in test signal genera- tor, which can have its output switched into each Loud- speaker manually or automatically. The desired test signal volume levels of each Loudspeaker can be determined, in

the Listening/Viewing Area, either by listening or with a sound pressure meter. Level adjustments are made in small steps (1dB) by using the MVP871 Remote Control Up or Down directional Push-buttons. The level can be adjust- ed over a 10dB range.

Note: Before performing the Loudspeaker Level adjust- ments, you must first have completed the Loudspeak- er Size adjustments.

1. Use the Down
directional
Push-button to
select CHAN-
NEL LEVEL
followed by
pressing the
SELECT Push-
button on the
Remote Con-
trol. Refer to	Figure 13
figures 13 and
14.
2. Use the
Down direc-
tional Push-
button to select
TEST TONE
then press the
Right or
Left direc-
tional Push-but-	Figure 14
tons to select
the
MANU-
AL Se-
lection
Mode of
op-
eration.
Refer to
figure
15.	Figure 15

Note: The procedure used for making the Loudspeaker Level Adjustments is similar for both the Manual and Automatic Modes. The only difference is, in the Manual Mode the selection of the Loudspeaker is performed by using the Up or Down direc- tional Push-buttons before adjustments are made. In the Automatic Mode, the MVP871 will switch

23