10
OUT
IN
OUT
IN
OUT
IN
NOTES:•A clear picture will not be obtained by the VCR unless the antenna signal is good. Connect the antenna to the
VCR properly.
•For better quality recording, an indoor antenna or a telescopic antenna is not recommended. The use of an
outdoor type antenna is required.
•If you are not sure about the connection, please refer to qualified service personnel.
If you are using an antenna system, follow the instructions. If you are a cable (CATV) subscriber,
skip ahead to
page 12 for the proper connections.

ANTENNA TO VCR CONNECTION

The VCR must be connected "between" the antenna and the TV. First, disconnect the antenna from the TV and connect
it to the VCR. Then connect the VCR to the TV. Below are 3 common methods of connecting an antenna system to a
VCR. Find the type of antenna system you are using and follow the connection diagram.
If both VHF and UHF antennas have 300 ohm twin lead (flat) wires, use a combiner having two 300 ohm
inputs and one 75 ohm output.
NOTE:
BASIC CONNECTIONS

Combination VHF/UHF Antenna with 75 ohm Coaxial Cable

Combination VHF/UHF Antenna with 300 ohm Twin Lead (Flat) Wire

Separate VHF and UHF Antennas

1
2
3
VCR
VCR
VCR
VHF UHF
300 ohm Twin Lead (Flat) Wire
Matching Transformer
300 ohm Input
75 ohm output
(not supplied)
300 ohm Twin Lead (Flat) Wire
75 ohm Coaxial Cable
75 ohm Coaxial Cable
Combiner
75/300 ohm Inputs
75 ohm output
(not supplied)
4E30401A E P08-13 17/04/2001, 14:2610