Dishwasher installation
4.Aligning the control panel with the drawer fronts.
The control panel can be aligned with the drawer fronts of the kitchen cabinets by adjusting the spacer bars.
Using an 8 mm socket, turn the nut clockwise or counterclockwise until the spacers reach the required height.
If necessary, individual (or all) spacer bars can be removed.
Adjustment range
from 4 1/2" control panel with- (112 mm): out spacer bars,
to 5 3/4" | control panel with |
(145 mm): | four spacer bars, |
to 6": | using a fifth spacer bar |
(154 mm): | (optional accessory). |
After adjusting the control panel height, cut off the plastic screw ex- cess.
5.Installing the custom door panel.
A custom door panel matching the kit- chen cabinetry can be installed on the dishwasher by using the provided tem- plates and bracket.
Length: | 21" - 25 3/4" (53.3 - 65.4 cm) |
Width: | 23 1/2" (59.8 cm) |
Note: The maximum panel length is only applicable when no spacer bars are used.
If a Stainless Steel panel is being used, please follow the separate installation instructions included with the panel.
After panel installation, see Step 6 “Ad- justing the door springs”.
Place a template on each end of the bracket as shown, making sure the rule marks face the outside of the bracket.
55
