Dishwasher installation
Hang the bracket on the machine door.
Slide the top edge of the templates under the spacer bars and control panel.
Slide the mounting bracket up or down until the oblong holes on the machine door align with the corre- sponding marks on the template (as shown in the left side of inset D.
Draw a line on each template that is even with the top edge of the ad- jacent cabinet door (inset E).
Remove the bracket from the door.
Place the door panel on a flat sur- face, good side facing down, taking care not to scratch the surface. Make certain that the bottom of the panel is closest to you.
Place the bracket on the back of the door panel and adjust it so that:
–the lines you drew on the templates align with the upper edge of the door panel and;
–the mounting bracket is centered (left to right) on the door panel.
Tape the bracket to the door panel to hold it in place while the mounting holes are being drilled.
Proceed to step “Drill pilot holes ...”.
56
