Troubleshooting
... One of the following has occurred:
–The Booster has automatically
–The 10, 11 or 12 power level set is alternating in the display with a lower power level. The reduced power level is also represented by the number of segments in the light ring.
The overheat protection is being triggered (see the section on "Overheat protection").
... With the Auto heat function switched on, the food in the pan does not cook.
This may be because:
–There is too much food in the pan.
–The cookware does not conduct heat well.
Select a higher continued cooking setting next time, or start cooking at the highest setting and then switch down manually to a lower setting later on.
... Numbers light up in the timer display and A, F and numbers light up in the cooking zone display, when the cooktop is switched off.
The sensitivity of the sensors has been altered and they cannot recalibrate automatically. Recalibration must be performed manually (see "Calibrating the sensor switches").
Should the problem still persist, please call customer service.
... An F , appears in the left cooking zone display, and an E in the right, and numbers appear in the timer display.
Interrupt the power supply to the cooktop for approximately 1 minute.
If the problem persists after power is restored, please call customer service.
... The cooling fan continues to run after switch-off.
That is not a malfunction. The fan runs until the appliance is cooled down, and then switches off automatically.
42
