3. Connecting to the Network
This section provides the installation procedure and instructions for assigning an IP address.
Pre-Installation Requirements
Before you start hardware installation, make sure you have the items listed below.
zPCs with 10/100Mbps Ethernet NICs or 100Mbps Fiber NICs: Your PC must have a standard Ethernet interface to connect to the switch.
zUTP cable with
zA power outlet with range 100 to 240VAC at 50 to 60 Hz: Make sure that the power switch is accessible and cables can be connected easily.
zDedicated power supply: Use dedicated power circuits or power conditioners to supply reliable electrical power to the network devices.
zA dry cool place: Keep the switch away from moisture. Avoid direct sunlight, heat source, and high amount of electromagnetic interference around.
zMounting tools: If you intend to mount the switch on a rack, make sure you have all the tools, mounting brackets, screws etc.
CAUTIION::
cCabling must be away from sources of electrical noise such as radio, computers, transmitters, broadband amplifiers, power lines and keep away from TVs, hair dryers, and microwave.
cAirflow around the switch and through its vents on the rear cannot be restricted.
Mounting the Switch
The
11
