SECTION 6 − MAINTENANCE &TROUBLESHOOTING
6-1. Routine Maintenance
Y |
Disconnect power before maintaining.
.Maintain more often during severe conditions.
3 Months
Replace unreadable labels
Repair or replace cracked weld cable
Clean and tighten weld terminals
6 Months
Blow out or vacuum inside.
OR
Remove drive roll and carrier. Apply light coat of oil or grease to drive motor shaft.
|
| Ref. 802 990 | |
|
|
| |
| 1 | Supplementary Protector CB1 | |
| If CB1 opens, wire feeding stops. | ||
| 2 | Welding Gun | |
1 | Check gun liner for blockage or | ||
kinks. | |||
| |||
| 3 | Wire Drive Assembly | |
| Check for jammed wire, binding | ||
| drive gear or misaligned drive rolls. | ||
| Allow cooling period and reset | ||
2 | breaker. Close door. | ||
3
Ref. 803
