![](/images/new-backgrounds/1049431/49431297x1.webp)
Installing
Install Peripheral Interface Cards
To install the Peripheral Interface cards:
CAUTION: To prevent static damage to electrical components, ensure that the system is grounded before you install the cards. Whenever you handle circuit cards, wear an
1.Install the peripheral switch controller card in slot 16.
2.Set the E&M Trunk Card settings and the OPS Line Card Message Waiting Switches in the Peripheral Unit Specifications section.
3.Install the Peripheral Interface cards. Refer to Install a Circuit Card in "Install Upgrades and FRUs" for circuit card installation procedures.
Cable the Unit to the MDF
Cable the lines and trunks from the Peripheral Unit to the Main Distribution Frame (MDF) by using the Peripheral Interface Cabling Tables.
About Peripheral Interface Cabling
Peripheral equipment (e.g., stations, SUPERSET telephones, trunks) is connected to the relevant interface circuits of the system via a
Plugs J1 through J8 are hardwired to backplane connectors in slots 1 through 12 to form four slot groups, each comprising three adjacent cards and each associated with a pair of plugs. Two adjacent slot groups are shown in Backplane Connector Arrangements. The circuits of interface cards contained in a slot group are evenly distributed to the relevant pair of plugs, such that, half the circuits of each card in a group are connected to the
Cable jacks (P1 through P8), are
Release 3.3 | 141 |