Mitel 3300 manual Restoring the database, Release 201

Install Upgrades and FRUs

34.Log in to the 3300 ICP ESM using the default username (system) and password (password). You see the 3300 ICP ESM main tools menu.

Tip: If your login fails, it may be because the system is not finished loading. Once you see "Voice Mail successfully started" in the RTC, you should be able to log in.

35.Set the options in the License and Option Selection form according to your purchased Mitel options.

Note: Since the installation of new software erases all of your system settings, you must complete this form even if you have not purchased any new options.

To set the options:

-At the main tools menu, click System Administration Tool.

-Click in the Selection: drop-down menu, where it says [Click here to start].

-Click System Configuration, click System Capacity, and then click License and Option Selection. You see the License and Option Selection view.

-Click Change in the top right corner. You see a pop-up window.

-Click OK to proceed to change your options. (Clicking Cancel will return you to the License and Option Selection view.)

-Enter the purchased system options. Note that you can change the Country, Net- working Option, Mitai/Tapi Computer Integration, and Extended Agent Group fields without a new Mitel Options Password.

-Enter your Mitel Options Password, and click Save.

Timer: The system can take up to 3 minutes to save your changes.

Restoring the database

36.A pop-up window instructs you, "If you have a database to restore, do that now. If there is no database to restore, reboot now." Click OK. (You will be restoring a database).

37.In the Selection: drop-down menu, click Maintenance and Diagnostics and then click Restore.

38.Type the location of the database that is being restored, or use the browse facility.

39.Click Start Restore. A window warns you that you must manually reboot after a restore and that a restore replaces the current database.

40.Click OK. The system will show an "in progress" message and then a "complete" message.

41.Click OK.

42.Click the Exit button until you are logged out of ESM.

43.Manually reset the system by pressing the Reset button on the 3300 Controller.

Note: The system does not allow you to log in during the restore and reset period. Once the system has completed the restore and reset, you should see "deleting/ipservicesdb.tar" in the RTC. This is a good indication that you can log back in to the 3300 ESM.

Release 3.3 201