SETTING THE MENUS
RECORDING SET UP
1SETTING THE ALARM REC MODE (ALARM REC MODE)
Sets the alarm recording time mode. When the JOG dial is turned, the display will be switched in the order of 3H } L12H } L24H } 3H } ....
2SETTING THE ALARM REC DURATION (ALARM REC DURATION)
Sets the duration of the alarm recording period. When the JOG dial is turned, the display will be switched in the order of 1M(minute) } 2M } 5M } 10M } MAN1 } MAN2 } 15S(second) } 30S } 45S } 1M } .... Refer to “ALARM RECORDING” on page 22.
3SETTING THE EMERGENCY REC (EMERGENCY REC)
<RECORDING SET UP> | 3H |
ALARM REC MODE | |
ALARM REC DURATION | 1M |
EMERGENCY REC | OFF |
ONESHOT•FIELD | 1 |
ONESHOT•INTERVAL | SHOT |
|
|
Sets the emergency recording mode.
OFF: Starts alarm recording when the alarm signal is received during recording.
ON: Starts alarm recording when the alarm signal is received not only during recording but also when the power is OFF or when the tape is stopped.
N
•When “ON” is selected, the alarm recording begins even though the recorder is in recording standby mode.
4SETTING THE NUMBER OF FIELDS IN
Sets the number of recorded fields in the
5SETTING THE INTERVAL TIME IN THE
Sets the interval time in the
REAR TERMINAL
1SETTING THE CALL SIGNAL OUTPUT AT THE END OF THE TAPE (CALL OUT)
Enables or disables the signal that is output from the CALL terminal when the end of the tape is reached during recording. If any abnormalities occur during recording, a CALL signal is output from the CALL terminal on the rear panel regardless of CALL OUT setting.
WRNG•TAPE END: | A signal is output at the end of the tape or when a malfunction occurs. |
WRNG•REMAIN: | The signal is output when a malfunction occurs in this VCR or when the |
| tape has approximately 3 minutes left in 3H mode. |
WRNG: | When a malfunction occurs in the VCR during recording, a CALL signal is |
| output. |
<REAR TERMINAL>
CALL OUT | WRNG•TAPE END |
CLOCK OUT | REC- 1 |
MODE OUT | REC |
REC IN | SERIES |
This is used in conjunction with TAPE END (FIRST TIME SET UP) to determine when the CALL signal is output as shown below.
CALL OUT
TAPE ENDsetting setting
STOP
REWIND
REPEAT
WRNG•TAPE END
Outputs a call signal at the
end of the tape
Outputs a call signal at the end of the tape for 2 seconds
WRNG•REMAIN
Outputs 3 minutes before
the tape end
WRNG
When a malfunction occurs in the VCR during recording, a call signal is output.
When there are no ALARM alarm recordings during recording
• PROT
When there are alarm Outputs a call signal at the
recordings duringend of the tape recording
10
