Mitsubishi Electronics HS-S8300E(BRS) Command Commands sent to the VCR Format, Parameter

The commands sent from the personal computer (or other equipment) to the VCR and responses produced by the VCR are detailed in this section.

1When controlling only one VCR via the personal computer, the "VCR ADDRESS" is set to "NONE". (Refer to page 29, item 7.)

1. Command: Commands sent to the VCR.

Format:	Command		Parameter	,			Parameter
	Codes	1				2
2. Status:	Response codes from the VCR.
Format:	Status	Parameter		,	Parameter
			1				2

,

,

• • • • •

• • • • •

,

,

Parameter

n

Parameter

n

Delimitter

#1

Delimitter

#2

N

#1: When you set "DELIMITTER<RECEIVE> to "CR", input the carriage return code (0DH).

When you set "DELIMITTER<RECEIVE> to "CR • LF", input the carriage return code (0DH) and line feed code (0AH).

#2: When you set "DELIMITTER<SEND> to "CR", the carriage return code (0DH) will be inputted.

When you set "DELIMITTER<SEND> to "CR • LF", the carriage return code (0DH) and line feed code (0AH) will be inputted.

[Example 1] Switch on the VCR. (When the DELIMITTER<SEND> and DELIMITTER<RECEIVE> of the RS-232C menu is set to CR.)

Sending commands	Status or error code from	Meaning
from the PC etc.	the VCR to PC etc.
PW1 CR		Power ON command
	RC CR	Command received
	EX CR	Command carried out

•

CR , which indicates carriage return code (0DH).

[Example 2] Recording was attempted, but could not because the erasure prevention tab of the tape was broken. (When the DELIMITTER<SEND> and DELIMITTER<RECEIVE> of the RS-232C menu is set to CR.)

Sending commands	Status or error code from	Meaning
from the PC etc.	the VCR to PC etc.
RC CR		Command for recording
	RC CR	Command received
	ER02 CR	Failed because the erasure prevention
		tab of the tape is broken.

•CR , which indicates carriage return code (0DH).

31