Playback
Operating Your Remote Control
Installing the Batteries
1To remove the back cover, press the ridged area gently, then push the cover in the direction of the arrow and lift.
2Load the batteries, making sure the polarities (+) and (Ð) are correct. This is marked inside the battery compartment.
Next, you need to tell the remote control to operate the VCR, not the TV.
Operating the VCR with the Remote Control
The
1Set the VCR/TV slide switch on the remote control to VCR position. This ÒtellsÓ the remote that you want to control the VCR.
Now your remote is ready to operate your
Loading a Tape
Tapes can be loaded into your VCR as long as the VCR is plugged in. Even when the VCR POWER is off, loading a tape will automatically turn the VCR on. Use only tapes that have an 
or 
label.
1Hold the tape so that the long narrow edge with the contents label faces you. The other edge is hinged and should face the VCR. The plastic window that shows the videotape should face up.
2Gently insert the tape evenly into the cassette slot until the VCR automatically takes it in.
If the VCR will not automatically take the tape in, press EJECT and try again.
Your VCR will eject the tape if it is loaded improperly. If the VCR ejects the tape; remove the tape, check to see that the contents label is facing you, that the geared tape reels are facing down, wait a few seconds, and try again.
Playing a Tape
1Press PLAY on the front panel or the remote control.
The VCR will automatically play the tape at the correct speed. When the VCR reaches the end of the tape, it will automatically rewind to the beginning of the tape and stop.
You can stop playing by pressing STOP.
CORRECT
INCORRECT
1 2 3
4 5 6
PLAY
7 8 9
0
STOP
STOP
PLAY
10
