Mitsubishi Electronics HS-U748 manual Selecting S-input Setting

Recording

IMPORTANT

For the best quality recording, use S-VHS tapes and record in the S-VHS format.

The quality of S-VHS ET recordings will vary by the quality of VHS tapes used. For the best quality S-VHS ET recordings, it is recommended that you use HG grade tapes.

S-VHS recordings can be played on:

¥S-VHS VCRs

¥VHS VCRs with S-VHS Quasi playback capabilities

S-VHS ET recording can be played on:

¥S-VHS VCRs (not all S-VHS VCRs will be able to play S-VHS ET)

¥VHS VCRs with S-VHS Quasi playback capabilities Please use this VCR or S-VHS VCR with S-VHS ET mode to playback the tape recorded in S-VHS ET for better picture quality.

Selecting S-input Setting

To watch the picture from the other equipment that is connected to the HS-U748 rear panel through the VCR, you have to select the S-video input jack or video input jack that matches the equipment.

1Press MENU on the remote control. VCR Main Menu appears.

2Press the ADJUST buttons on the remote control to select S-VHSSet-Up. Press ENTER.

3Press the ADJUST buttons to select Rear S-input.

4Press ENTER to select which input jack to input.

¥select OFF when you want to input signals from video input jack.

¥select ON when you want to input signals from S-video input jack.

5Press MENU twice to exit the menus.

ÈS-VHS Set-Up￿		￿
	ÄS-VHS Auto record			ON
	ÄS-ET record		Auto	ON
	ÄRear S-input			ON
	￿

￿

º¹MENU to go back￿

¶¹¹ADJUST to select￿ ²´³¹ENTER to change￿

· ¹¹ADJUST to select

OFF￿ OFF￿ OFF￿

22