Mitsubishi Electronics LT-37131 manual Appendix C Troubleshooting, continued, Appendices, Symptom

Appendices 101

Appendix C: Troubleshooting, continued

IEEE 1394 Devices

	Symptom	Remarks
5.	The IEEE 1394 device cannot be selected (is	The device may be busy with a recording. Cancel the recording.
	grayed out).
6.	When the Input Selection Menu is displayed,	• The IEEE 1394 device does not provide a menu.
	a menu does not display when I press the	• The TV cannot support IEEE 1394 menus.
	MENU button.
7.	All IEEE 1394 devices disappear.	• The connected devices must not be in a loop that returns to
			the TV. Make sure a device is connected at the end.
		• Disconnect all the cables and devices from the TV. Replace
			them one by one to locate the problem device or cable.
		• Use System Reset (front control panel).
8.	Cannot rediscover a deleted IEEE 1394	The device has been disconnected. Plug it in.
	device.
9.	An IEEE 1394 device has been plugged in	• The IEEE 1394 connection to the TV or another device is not
	but does not appear in the Input Selection		secure or is loose.
	menu (not discovered).	• The IEEE 1394 device is not powered on.
		• A device in the IEEE 1394 chain is not powered on. Turn on
			all the devices.
		• The device discovery can take as long as a minute to initiate.
		•	IEEE 1394 cable is too long (maximum of 15 feet between
			devices).
		• The IEEE 1394 device uses an incompatible protocol and will
			not be discovered.
		• The TV can not decode DV video.
10.	Cannot view video from an IEEE 1394 DV	Use analog connections for video and audio. You can still use the
	camcorder.	IEEE 1394 connection for control functions, however.
11.	An IEEE 1394 device is not responding	•	Unplug the device’s power cord. Wait at least ten seconds
	properly.		and plug it in again.
		• Some IEEE 1394 devices are not supported by the TV
			because of incompatible standards.