Mitsubishi Electronics LT-37131 Appendix C Troubleshooting, continued, Appendices, Picture, Sound

Appendices 99

Appendix C: Troubleshooting, continued

Picture

	Symptom		Remarks
9.	DVCR analog/digital problems.		If the tape is currently playing but no picture displays, there
			may be a mismatch of the media with the display. Press INPUT
			to display the Input Selection menu. Press ENTER for the DVCR
			device. If digital is selected, try analog, or if analog is selected, try
			digital.
Indicators
	Symptom		Remarks
	Status indicator light is a steady/flashing red.		Service is required. Contact your dealer or a Mitsubishi Autho-
			rized Service Center to arrange for a service evaluation. Listings
			of Mitsubishi Authorized Service locations can be obtained from
			our web site, www.mitsubishi-tv.com or by calling 1-800-332-2119.
Sound
	Symptom	Remarks
1.	There is no sound even when the	• Check if the MUTE button is on.
	volume is turned up.	• The TV’s “Listen to:” setting may be set to SAP.
		• Check that the TV Speakers setting is On in the Audio/Video menu.
		• If using an IEEE 1394 amplifier, check audio source in Input Selection
			menu.
		• Perform System Reset.
2.	The sound does not match the screen	• The TV’s Listen to: setting may be set to SAP.
	picture.	• If using stereo or A/V receiver speakers, check their input selec-
			tion.
		• If using stereo or A/V receiver, check that AUDIO OUTPUT LEFT/
			RIGHT or DIGITAL AUDIO OUTPUT on TV’s back panel is con-
			nected to the A/V receiver.

IEEE 1394 Recording

	Symptom	Remarks
1.	Program to be recorded was correctly	The broadcaster supplied program information that was incorrect
	selected from ChannelView, however, incor-	and/or was changed after a recording was added to the Record
	rect program was recorded.	List.
2.	Incomplete ChannelView program recorded.	Recording device may lack sufficient blank space to make a full
		recording.
3.	ChannelView program recording failed.	• Connection and compatibility issues with IEEE 1394
		(FireWire®) digital devices. This may include too many
		Firewire devices in use at one time, or the recording device
		not understanding the record command.
		• Television lost power long enough to lose current clock time.
		• TV energy Mode was set to Low Power. Change TV Energy
		mode to Fast Power On. Press MENU, open the Setup menu,
		highlight the Fast Power On radio button, press ENTER.