Mitsubishi Electronics LT-37131 manual Older Cable Box, Camcorder, TV Connections

Chapter 2. TV Connections 33

Older Cable Box

Required: 3 coaxial cables, one two-way RF splitter. These are not included with the TV.

When this setup is complete, you can use the TV remote control, when programmed, to change channels on the cable box.

Note: This connection is not recommended. The other connections described in this chapter provide bet- ter quality audio and video to the TV.

1.Connect the incoming cable to IN on the RF splitter.

2.Connect one coaxial cable from OUT on the RF split- ter to ANT 1/MAIN on the TV back panel.

3.Connect one coaxial cable from OUT on the RF split- ter to IN on the standard cable box.

4.Connect one coaxial cable from OUT on the cable box to ANT 2/AUX on the TV back panel.

�������

�������

�������			����������������
�������
				���������������
		������������������		��������������������
				�������������������
				��		��
				���������������� ������
��		��			��
				��
���	��		����������	�����������		���������
						�����
			����������

Camcorder

Required: Analog stereo audio cables and either an S- Video or composite video cable.

NOTE: For IEEE 1394 camcorders, see also chapter 7, “Using IEEE 1394 Devices.”

1.Connect either an S-Video or composite video cable from VIDEO OUT on the camcorder to INPUT 3/VIDEO or S-VIDEOon the TV. Connect only one type of video cable; S-Video is recommended, if avail- able.

2.Connect left (white) and right (red) audio cables from AUDIO OUT on the camcorder to INPUT 3/ AUDIO L and AUDIO R on the TV.

�������������������

���������

Figure 15. Connecting an older cable box

Note: ANT 1 is located behind ANT 2 when you are facing the back of the TV.

�� �� ��

���������������������

������������� ��

Figure 16. Analog connections for a camcorder