Mitsubishi Electronics VS-60609 service manual Adjustment procedures after replacing the CRTs

MODELS: VS-45609 / VS-50609 / VS-55609 / VS-60609 / VS-60719 / VS-70709

2.Install the Deflection Yoke on the CRT neck. [Figure 5-7]

3.Install the Lens that was removed in steps 5 and 6 of Removal Of The CRT. [ Figures 5-1 and 5-2 ]

a)Position the Lens so that the Label faces the direction shown in Figure 5-8.

b)Install the mounting screws. [Figure 5-1]

4.Install the PCB-CRT.

5.Insert the Optical Unit into the Light Box Assembly.

6.Insert the Anode Lead Wire into the Flyback Transformer.

7.Re-clamp the Lead Wire in its original position.

Figure 5-7

Figure 5-8

Adjustment procedures after replacing the CRT(s)

•CRT Cut Off / White Balance Adjustment

•Static Convergence Adjustment

•Dynamic Convergence Adjustment

Page 16