Mitsubishi Electronics WD-62327, WD-52327 manual Connecting an Antenna to a Cable Box or VCR

Connecting an Antenna to a Cable Box or VCR

Antenna to a Cable Box

(Figure 3)

1.Connect the incoming cable to ANT-A on the TV back panel.

Connect two coaxial cables as follows:

2.One from LOOP-OUT on the TV back panel to IN on the cable box back panel.

3.One from OUT on the cable box back panel to ANT- B on the TV back panel.

Antenna to a VCR

(Figure 4)

1.Connect the incoming cable to ANT-A on the TV back panel.

Connect two coaxial cables as follows:

2.One from LOOP-OUT on the TV back panel to ANTENNA IN on the VCR back panel.

3.One from VCR back panel ANTENNA OUT to ANT- B on the TV back panel.

Note: If your cable box has separate audio/video outputs, connect the audio as shown in Figure 6, page 14.

Note: If your VCR has separate audio/video outputs, connect the audio as shown in Figure 6, page 14.

	�������������������������������
	�� � � �	� �� �	� � � � �
��������������		���
	�
�

��������������

�������������������������������

	� �� �
�� � � �	��� � � � � �

�

�

�

��������������

�	���������	��������	���������
��	�	�	�����
�������	�	�	�
			�������

���������

�������������������������������

�

���

� �

�� ���

Figure 3. Connecting the cable box.

Figure 4. Connecting the VCR with antenna or wall outlet cable.

Note: When the Energy Mode is set to Low, the VCR may not record programs when the TV is off.

Note: For digital cable boxes, refer to your Digital Cable Box owner’s guide for instructions on optimal connections to this TV.

13