Use of the Remote Control with Other A/V Products, continued
| CABLE/DBS/DTV |
| VCR | DVD |
| ||||||
| TV |
|
|
|
|
|
|
|
| AUDIO | 2. POWER |
|
|
|
|
|
|
|
| ||||
1. |
|
|
|
|
|
|
|
|
| ||
3. |
|
|
| A/V | Receiver Codes |
| |||||
| Audio brand |
|
|
| Code to enter: | If your | |||||
| Mitsubishi A/V receiver | 010, 015, 011, 012, | |||||||||
| audio | ||||||||||
| and/or CD player |
|
|
| 013, 014 | ||||||
|
|
|
| code is not | |||||||
|
|
|
|
|
|
| 234, 235, 236, 245, | ||||
| Denon |
|
|
| listed here, | ||||||
|
|
|
| 246, 359 | please see | ||||||
|
|
|
|
|
|
| |||||
| Harman Kardon |
|
|
| 215, 223, 242 | page 60 | |||||
| JVC |
|
|
| 233, 232 | for a | |||||
| Kenwood |
|
|
| 208, 200 | complete | |||||
| Marantz |
|
|
| 224, 350 | listing. | |||||
| Onkyo |
|
|
| 209, 214, 240, 247 |
| |||||
| Pioneer |
|
|
| 205, 207 |
| |||||
| Sony |
|
|
| 222, 249 |
| |||||
| Technics |
|
|
| 218, 219, 221 |
| |||||
| Yamaha |
|
|
| 202, 201, 243, 244 |
| |||||
| To reset to default | code, enter 000 |
| ||||||||
Figure 5. Programming the remote to control your A/V receiver.
If the slide switch is set to TV when you enter an A/V receiver code, VOLUME and MUTE will control the A/V receiver rather than the TV. To return volume and mute control to the TV, set the slide switch to TV, press and hold POWER and enter 000.
After entering the correct codes in each position of the remote control, use the slide switch to select which product will respond when an operational button is pressed. If you enter a code from the A/V Receiver Codes chart while the slide switch is set to TV, the volume and mute functions change to match the A/V receiver. This is useful when using an A/V receiver with the TV all the time. In all other cases, only one of the below devices is allowed for each slide switch position.
TV position:
•TV
•A/V receiver (volume and mute only) Cable/DBS/DTV position:
•Cable box
•Satellite receiver
•DTV receiver
VCR position:
•VCR
DVD position:
•DVD
•LD Player Audio position:
•A/V receiver
•Mitsubishi CD player
Some manufacturers may change their products, or they may use more than one remote control system. If this is the case, your remote control may not be able to operate your VCR, DVD, cable box, satellite receiver, or A/V receiver.
If you have a Mitsubishi A/V receiver, the audio position may be used in conjunction with select Mitsubishi CD players. Your audio position must be programmed to either 010 or 011. Plug the CD player power cord into a switched outlet on the back of your A/V receiver. Pressing the POWER button turns On the A/V receiver, along with the CD player. In the audio position, for some CD players, the transport controls (FF, Play, Rew, etc.) operate the CD player.
26
