Mitsubishi Electronics WD-62327, WD-52327 Connecting a DTV Receiver, DTV Connectors and Adaptors

Connecting a DTV Receiver

Contact your local cable or satellite provider or refer to the cable box or satellite Owner’s Guide for instructions on optimal connections to this TV.

DTV Connectors and Adaptors

(Figure 11)

The TV back panel has 5 RCA-type connectors for the DTV connection. The back panel of your DTV receiver may use RCA-type connectors or BNC-type connectors. If your DTV receiver comes with BNC type connections, you will need to purchase BNC to RCA adaptors to connect the TV to the DTV receiver. These adaptors should be available at most electronic supply stores.

			or
BNC to		Adaptor	RCA
RCA	BNC	Fitted to	Connector
Adaptor	Connector	Connection

Figure 11. DTV connectors and adaptors.

See Appendix B, page 59, for component video signal compatibility information.

For digital audio connections, see your DTV and A/V receiver Owner’s Guides.

DTV Receiver with Component Video Connections (Recommended)

(Figure 12)

1.Connect the outside antenna cable, or satellite to ANT or SATELLITE IN on the DTV receiver (see your DTV receiver owner’s guide for instructions and cable compatibility).

2.If your DTV receiver has a built-in integrated digital tuner, connect the incoming integrated antenna to ANT on the DTV receiver. If your DTV receiver does not have a built-in terrestrial tuner, this TV will only be able to provide an analog signal through Ant-A or Ant-B on the TV back panel.

3.Connect the RCA-type cables from the DTV receiver outputs to DTV INPUT Y/Pb/Pr on the TV back panel. You may need to access the Input Assignment menu (page 33) to set the DTV Input to Y/Pb/Pr.

4. Connect the L (left) and R (right) audio cables from the DTV receiver to DTV AUDIO on the TV back panel.

5.To utilize the benefits of a digital A/V receiver, connect your DTV receiver’s digital audio out to a digital input on your digital A/V receiver.

Component (1 and 2) may also be used for 1080i components.

TV Back Panel (section detail)

COMPONENT		DTV(YPbPr/ GBRHV )
480 i / 480P/ 1080i		480i / 480P /1080 i
1	2

Y3

3 H

P

3	V
P
AUDIO -	White
L E FT /	4

AUDIO -	4
RIGHT		Red

DTV Receiver (with component video connections)

							CAUTION
							RISK OF ELECTRICAL SHOCK
		AUDIO	AUDIO		White		DO NOT OPEN
	3	Y	L	L	VCR
					CONTROL4	OUT TO TV
	3				4	CH 3
		Pr	R	R		CH 4
						DIGITAL
	RF				Red	AUDIO OUT
	3	Pb
PHONE JACK	REMOTE	V IDEO	V IDEO
					S-VIDEO	IN FROM ANT	SATELLITE IN

1 or 2

incoming antenna, cable or satellite

Figure 12. Connecting the DTV receiver with component Video Connections.

17