15
06/08 Rev. AA | QUICK REFERENCE |
| 9864 |
Starting to print
| Settings for the material type |
| The parameter settings below describe setting up the label material. |
| When printing from a layout program, these settings are usually provided |
| automatically by the printer driver. For your first test prints, you need to |
| configure them manually. |
Material type | y The label material is endless (continuous) which means that it contains no |
| punches/perforations, breaks or reflex marks that could be recognized by the |
| punch (die cut) sensor: |
| Set the PRINT PARAMETER > Material Type to endless. |
| y The label material contains punches/perforations, breaks or reflex marks that |
| can be recognized by the punch sensor |
| Set the PRINT PARAMETER > Material Type to “Punched.” |
Material length | Set the PRINT PARAMETER > Material Length to the length of the material (in mm). |
Material width | Set the PRINT PARAMETER > Material Width to the width of the material (in mm). |
| Only for punched/perforated (die cut) material: |
Type of punch | y Label material with breaks or punches: |
| Set the SYSTEM PARAMETER > Sensor Type to Punched. |
| y Label material with reflex marks: |
| Set the SYSTEM PARAMETER > Sensor Type to Reflex. |
| For more information on setting parameters: refer to |
| Parameters.” |
| Printing the status report |
| To test the printer, print a status report. The width of the status printout can |
| be set to 4 inches (100 mm) or 2 inches (50 mm). This should match the width |
| of the label material used. The length of the printout is 8 inches (200 mm). |
| |
(100 mm) | Navigate to INFO PRINTOUT > Printer Status. |
| The printout (two |
| settings. |
| |
(50 mm) | Set the SYSTEM PARAMETER > Print Info Mode to “Compact right.” |
| Navigate to INFO PRINTOUT > Printer Status. |
| This printout contains the same information as the |
| compressed to a |