22
06/08 Rev. AA | QUICK REFERENCE |
| 9864 |
Cleaning the Sensors
Cleaning the gap photoelectric switch/sensor
1.Turn off the printer and disconnect the power supply.
2.Remove the material and ribbon.
3.Unscrew the two thumb screws on the printhead mounting and rotate the entire printhead mounting upwards.
PSee “Cleaning the Printhead” for more information.
If you need to remove the printhead, mark the position of an adjusted printhead on the axle.
The gap photoelectric switch can now be accessed.
4.Clean the gap photoelectric switch with compressed air or a
5.Return the printhead mounting to its original position and tighten the thumb screws.
Press the thumb screw on the tapered edge of the square axle and ensure the exact positioning of the printhead mounting on the axle. Also pay attention to the position of the printhead in relation to the edge of the label.
The printhead should be flush against the inner black plastic plug.
6.Connect the printhead cable.
7.Connect the power supply.
8.Turn on the printer.
Cleaning the material end photoelectric switch/sensor
The material end photoelectric switch is located on the inner red material feed on the print module. Clean the photoelectric switch when you see dust on it.
Clean the material end photoelectric switch with compressed air or a lint- free cloth moistened with isopropyl alcohol.