21

06/08 Rev. AA

QUICK REFERENCE

 

9864

 

5. Return the printhead mounting to its original position and tighten the thumb

 

screws.

 

Press the thumb screw on the tapered edge of the square axle and ensure

 

the exact positioning of the printhead mounting on the axle. Also pay

 

attention to the position of the printhead in relation to the edge of the label.

 

The printhead should be flush against the inner black plastic plug.

 

6. Connect the printhead cable.

 

7. Connect the power supply and turn on the printer.

 

Cleaning the dispenser-feed roller

Dispensor version only!

1.Turn off the printer and disconnect the power supply.

2.Remove he material and ribbon.

3.Remove the pull-out module (left side).

Fig. 5 Left side: remove the pull-out module; right side: cleaning the dispenser-feed-roller using isopropyl alcohol.

4.Moisten a lint-free cloth with isopropyl alcohol and wipe the feed roller clean. Turn the roller with your finger to clean the entire surface.

5.Replace the pull-out module.