20
06/08 Rev. AA | QUICK REFERENCE |
| 9864 |
CAUTION! - Only clean the print roller with a
6.Return the printhead mounting to its original position and tighten the thumb screws.
Press the thumb screw on the tapered edge of the square axle and ensure the exact positioning of the printhead mounting on the axle. Also pay attention to the position of the printhead in relation to the edge of the label.
The printhead should be flush against the inner black plastic plug.
7.Connect the printhead cable before turning on the printer.
Cleaning the feed roller
Clean the feed roller when you adhesive buildup or dirt on the roller.
1.Turn off the printer and disconnect the power supply.
2.Remove the material and ribbon.
3.Remove the printhead.
4.Moisten a
Shift the front material guiding (1) and the contact pressure rollers (2) for better access to the roller.
Fig. 4 To clean the feed roller, remove the printhead and shift material
guiding (1) and set the contact2 pressure rollers (2) aside.
1