5
06/08 Rev. AA | QUICK REFERENCE |
| 9864 |
Loading material
CAUTION!
Rotating axles! These can pull in and tear off hair, clothing and jewelry.
–Do not operate the printer with the cover open!
–Keep long hair, loose clothing, jewelry etc. away from the printer!
1.Open the cover.
2.Pull off the outer guide disk (1) of the unwinder (2).
3.Place the material on the unwinder with the corresponding adapter rings. The material roll should turn
4.Replace the outer guide disk of the unwinder.
5.Lay the material around the dancer arm.
6.Set the material guide to the material width. Loosen the thumb screw on the underside of the front material guide (3). Push the material guide sideways. Tighten the thumb screw (Fig. 2).
7.Press the red or green opener (4) of the intake to raise the pad rollers. Press and hold the opener and push the material through the material guide until it is below the printhead (Fig. 3).
8.Align the material so that it is straight. While holding down the loading lever, position the pad rollers so that both rollers
(5)sit symmetrically on the material. (The printhead has been removed in Fig. 4 to allow a better view).
1
2
3
4
