CDVX Series Direct Vent Gas Fireplace
Logs
The 36CDVX logs are shipped in place. If a log is broken, refer to the replacement parts list for a replace- ment. Figure 63 shows where the logs are secured to the fireplace.
Figure 63
Lava Rock
Flame & Temperature Adjustment
RN/RP & EN/EP Models
For units equipped with “HI/LO” valves the flame adjustment is accomplished by rotating the “HI/LO” adjustment knob located near the center of the gas control valve. (Figs. 64)
| SIT 820 Valve |
|
Turn |
| Turn clockwise |
counterclockwise | H | |
| I |
|
to increase | L | to decrease |
O | flame height | |
flame height |
|
Fig. 64 Flame adjustment knob for SIT valve.
Yellow Flame
Figure 66
LG481Separate the ember material into small pieces, roughly 1/2” in diameter and place on the front burner tube. Do NOT pack down, leave in fluffy, loose condition for most
realistic ember effect. (Fig. 62)
The lava rock provided with this fireplace must be placed on the firebox base around the burner assembly. (Fig. 63)
Under no circumstances should this lava rock be placed on any part of the burner.
LG480Ember Material
Flame Characteristics
It is important to periodically perform a visual check of the pilot and burner flames. Compare them to the illustrations. (Figs. 65 & 66)
If the flame patterns appear abnormal contact a qualified service provider for service and adjustment.
SIT RN/RP
FP1541Fig. 65 Correct pilot flame appearance.
Red Glow, Yellow Tips
30 | 20012253 |