Monessen Hearth 36CDVXTRN Operating Instructions, Glass Information, Louvre Removal, 7!2

Models: 36CDVXTRN

1 44
Download 44 pages 17.07 Kb
Page 29
Image 29
Operating Instructions

CDVX Series Direct Vent Gas Fireplace

Operating Instructions

Glass Information

Only glass approved by MHSC should be used on this fireplace.

The use of any non-approved replacement glass will void all product warranties.

Care must be taken to avoid breakage of the glass.

Do not operate appliance with glass front removed, cracked or broken.

Replacement glass (complete with gasket) is available through your MHSC dealer and should only be installed by a licensed qualified service person.

7!2.).'

(/4/',!33 7),,

#!53%5"52.3

$/ ./4 4/5#( ',!33

5.4),4#//,%$

.%6%2 !,,/77#(),$2%.

4/ 4/5#( ',!33

Louvre Removal

6.Tilt the window frame assembly out slightly at the bottom, lift the window frame assembly up and away from the fireplace.

7.To replace the window frame assembly reverse the procedure.

Glass Information Lower Clamps Louvre Removal

 

Window

 

Frame

Window

Assembly

 

Frame

Pull Clamp

Assembly

Hook

Push

Clamp

 

Handle

FP1228

 

Fig. 62 Window frame assembly removal.

Glass Cleaning

The top louvre panel is removed by lifting the panel vertically and pulling it away from the appliance. (Fig. 61) The lower access door is removed in the same manner.

2.Glass CleaningWindow Frame Assembly RemovalManual backgroundManual background

Louvre

1.

Manual background Glass Panel

FP1602

It is necessary to periodically clean glass. During start- up condensation, which is normal, forms on the inside of the glass. This condensation causes lint, dust and other airborne particles to cling to glass surface.

Also initial paint curing may deposit a slight film on the glass. It is therefore recommended the glass be cleaned two or three times with a non-ammonia based household cleaner and warm water (We recommend gas fireplace glass cleaner) within the first few weeks of operation.

After the initial cleaning process the glass should be

Fig. 61 Remove top louvre assembly.

Window Frame Assembly Removal

1.Turn the fireplace OFF (including the pilot)

2.If the unit has been operating allow time for the components to cool.

3.Remove the top louvre assembly.

4.Remove the lower louvre panel.

5.Release the two clamps securing the lower edge of the window frame assembly by pulling down on the handles. (Fig. 62)

cleaned two or three times during each operating season depending on the environment in the house.

Clean glass after first two weeks of operation.

Do not clean glass when hot.

Do not use abrasive cleaners.

Do not strike or slam the glass.

20012253

29

Page 29
Image 29
Monessen Hearth 36CDVXTRN Operating Instructions, Glass Information, Louvre Removal, Glass Cleaning, 7!2, 20012253