OPTIONAL ACCESSORIES | DFX & DBX Series Vent Free Fireplaces |
installing optional FIREbrick panels
Hole
1. Remove optional firebrick panels from packaging. Check that you have the following:
•3 firebrick panels
• | two (2) retainer brackets | Retainer |
• | two (2) black screws | Clip |
|
If any part or parts are missing, contact dealer where you bought fireplace.
2. Turn off fireplace and allow to cool.
3. Remove fireplace screen, Page 17, Figure 17 and logs.
4. Place rear firebrick panel on back wall of firebox. Set |
|
|
| |
bottom of panel behind the bracket tabs of the grate. |
|
|
| |
Figure 36 | Side Firebrick |
|
| |
5. Place one of the side firebrick panels in cabinet. Line | Panel | Screw |
| |
up the hole in the retainer clip with the hole inside the | Figure 37 - |
|
| |
firebox. Using Phillips screwdriver, attach the retainer |
| FP2521 | ||
bracket to inside of firebox. Figure 37 | Install Side Firebrick Panel | |||
|
|
| ||
6. Repeat step five for the other firebrick side panel. | black TRIM INSTALLATION |
| ||
|
| |||
Rear Firebrick | DFX24C/DBX24C |
|
| |
1. Remove black trim from protective packaging. Remove | ||||
Panel | ||||
| four (4) black screws and two (2) 90° angle trim brackets | |||
| from owner’s manual packaging. |
| ||
| 2. Lay trim on floor and match corners of side trims to top | |||
| trim. Figure 38 |
|
| |
Figure 36 - | Bracket Tabs |
FP2520 |
Install Back Firebrick Panel
FP2522
Figure 38 -
Match and Join Corners of
Black Trim with Trim Brackets
To Separate Trim
FP2523
33D4047 | 33 |
