DFX & DBX Series Vent Free Fireplaces | OPTIONAL ACCESSORIES |
3.Use one 90° angle trim bracket to join the corner of one piece of side trim to the corner of the top trim piece. Figure 38. A rubber hammer or handle of a claw hammer will help secure the corners.
4.Repeat for other side.
NOTE: If you do not attach the trim at the correct corners, use a hammer and screwdriver to tap on the one end of the 90° angle bracket. This will separate the two pieces of trim. Figure 39
5.Place assembled black trim on front of heater. Using four
(4) black screws, secure black trim to sides of heater. Figure 39
45° Angled 
Corners
Back of Trim
Assembly
Figure 40 - | FP2525 |
| |
Align Corners of Trim Pieces |
|
Black Trim
FP2524
Bracket | Bracket | |
| ||
| Screws | |
| Outside | |
| Corner Slot | |
Shim | No Spaces | |
Where Corners | ||
| ||
| Join | |
| Ensure Corners | |
Figure 41 - | are Flush | |
| ||
Secure Corners | FP2526 |
Holes for Black
Screws
Black Screw
Figure 39 -
Attach Assembled Trim to Fireplace
Black trim installation
DFX32C
1.Remove trim from protective packaging. Be careful not to scratch the trim. Remove two (2) 90° angled mounting brackets and two (2) 90° angled shims.
2.Lay trim face down on the floor. Line up the
Note: Both ends of the top piece of trim are mitered. Figure 40
3.Slide one (1) 90° angled bracket (with attached screws) and one (1) 90° angled shim in the outside corner slot where the top and side trims meet. Figure 41
4.Hold the corners together securely. Tighten screws on bracket with flat head screwdriver. Make sure the cor- ners are flush and there are no spaces. Do not over tighten screws. Figure 41
5.Repeat for other side trim.
6.Slide assembled trim over the top and down the sides of the fireplace. Flush trim with front of fireplace as shown in Figure 42.
7.Align holes in assembled trim with holes in side of fire- place. Using a Phillips screwdriver, attach trim with four
(4) screws provided — two for each side of fireplace. Tighten snuggly. Figure 43
34 | 33D4047 |
